Tengzhou Hunter Machinery Co., Ltd
+8613969499628

What should I do if the 315 ton hydraulic oil cylinder enters the foreign body?

Oct 25, 2022


What should I do if the 315 ton hydraulic oil cylinder enters the foreign body?

The oil cylinder is an important part of the 315-ton hydraulic press and plays a vital role in the entire hydraulic press. However, sometimes during its operation, foreign objects may enter the oil cylinder, and it is difficult for us to judge when the foreign objects enter the oil cylinder. inside. How can we solve the problem of foreign objects entering the cylinder?


        When a foreign object enters, if a seal with a lip is installed on the outer side of the sliding surface of the piston, the lip of the seal can scrape the foreign object during operation, which is beneficial to avoid scratches. However, the two ends of the piston with the O-ring seal are sliding surfaces, and if foreign matter is sandwiched between the sliding surfaces, it is easy to form scratches.

 When the unmoved surface pressure of the four-column hydraulic press piston and the cylinder block rises abnormally, it may cause sintering, resulting in metal fragments and scratches on the cylinder wall. When the two ends of the pipe are threaded or welded, chips or welding foreign objects are brought into the cylinder. There are burrs on the part, or the scrubbing is not sufficient. There are often burrs left during drilling in the oil port on the cylinder head or the buffer device, so you should pay more attention and install it after the sand is removed.


        The 315 ton hydraulic oil cylinder block may get foreign objects during installation. Because sometimes the oil cylinder enters the dust without knowing it. Therefore, be sure to clean up the surroundings before installation, and there should be no dust in the place where the parts are placed. There are usually chamfers on both sides of the sliding surface of the piston. The size of the chamfer and the surface finish should be strictly controlled, otherwise the casting particles at the corners will peel off during the sliding process, resulting in the loss of the sliding surface. The plunger fit of the buffer structure is tight or the lateral load on the piston rod is large.