Tengzhou Hunter Machinery Co., Ltd
+8613969499628

How to improve the working performance of the four-column hydraulic press?

May 16, 2022

How to improve the working performance of the four-column hydraulic press?

In order to better improve the working efficiency of the four-column hydraulic press, the following precautions should be taken before work:

Before the four-column hydraulic press starts to work, remove all kinds of dirt on the equipment, wipe off all stains on the rod of the four-column hydraulic press, maintain the flexibility of the mold, and check the couplings of the hydraulic oil pump and the motor. spectrum. Parts such as the four positioning pins, the surface of the piston rod, the mold shell, and the guide slider should maintain wettability. In addition, check limit switches and safety protection equipment to ensure that their operation is reliable.

2. The mold installation of the four-column hydraulic press must be carried out under the condition of power failure. It is strictly forbidden to hit the start button, rocker and push button switch. Install the left and right mold shells to align the vertical ends, adjust the inner diameter of the mold shells, and do not allow deviation from the management center. After the mold shell is fixed, the water pressure test is performed again (pay attention to the actual operation of the electric power switch to avoid destroying the mold shell under the control switch mode).

3. Before starting the four-column hydraulic machine, start the machine and equipment at high speed for five minutes to check whether the fuel tank of the car is sufficient, whether the sound of the gasoline pump is normal, and whether there is leakage in the hydraulic machine module, pipeline, connector, and piston rod.

4. Start the hydraulic test of the industrial equipment to check whether the working pressure is up to pressure, and whether the operation of the machinery and equipment is normal and reliable.

5. Adjust the pressure, but not exceed 90% of the rated working pressure of the four-column hydraulic press equipment. A product workpiece is tested by hydraulic pressure, and it is produced after the test meets the standard.

6. For different aluminum profiles and product workpieces of the four-column hydraulic press, when suppressing and calibrating, the pressure, suppression frequency and pressure holding time of the four-column hydraulic press should be adjusted anytime and anywhere to ensure that the mold shell and the product workpiece are not damaged.