First, the purpose
In order to standardize the safe operation of hydraulic presses and ensure safe production, this operating procedure is specially formulated.

2. Scope
Use with the factory operators.
3. Responsibilities
The hydraulic press operator shall operate in accordance with this operating procedure, and the workshop leader and team leader shall be responsible for supervision and inspection.
Four, operating procedures
1) The operator should be familiar with the performance and structure of the hydraulic press, and be certified for operation after training.
2) During the operation of the machine, no part of the body is allowed to enter the working space of the movable beam, and tools must be used to load and unload the workpiece.
3) The operator must wear personal protective equipment before starting the machine.
4) Perform a pre-work inspection, run by jog, and check whether the various functions of the hydraulic press are normal. If there is a problem, it should be dealt with immediately before starting work:
○ 1 Check whether there is oil leakage in various oil pipes, manifold oil valves, oil cylinders, etc.;
○ 2 Whether the movable beam is obviously sliding down, and whether the staying position is correct;
○ 3 Whether the photoelectric switch and emergency stop switch work flexibly;
○ 4 Whether there is noise from the hydraulic press;
○ 5 Whether the oil tank shows enough hydraulic oil;
○ 6 Check whether the piston of the oil cylinder is loose and whether the surface is lubricated with lubricating oil.
6). If two or more people are required to cooperate and operate, the front and rear operation switches must be turned on and the corresponding two-hand operation switches and emergency stop switches must be equipped.
7) It is strictly forbidden to work beyond the maximum stroke of the movable beam (that is, it shall not be less than the minimum closed height of the hydraulic press).
8) When working with full load, the maximum allowable eccentricity of the concentrated load is 50MM, and it should not be used with overload or exceeding the maximum eccentricity.
9) When the mold is overhauled, the machine must be stopped, and wooden blocks should be used to support the movable beam.
10). All pressure regulating valves and travel switches must be adjusted with special tools and personnel.
11). The cooling system must be turned on before starting the machine to ensure that the oil temperature does not exceed 60 degrees.
12). Pay close attention to whether the hydraulic machine is abnormal during work, and do not work with the machine.
13). The mold must be closed before stopping, then stop the oil pump and turn off the power.
14). After finishing the work, clean the machine tool, clean the site, and fill in the "Equipment Daily Maintenance Card"









