Tengzhou Hunter Machinery Co., Ltd
+8613969499628

Problems that occur when the four-column hydraulic press maintains pressure

Mar 31, 2022

Problems that occur when the four-column hydraulic press maintains pressure

The four-column hydraulic press is controlled by the time relay in the electrical control circuit when the pressure is maintained after pressurization, and can be dispatched within 0min-24min. During pressure holding, there is no oil movement in the system except that the hydraulic pump is unloaded at a lower pressure. Hydraulic pump-sequence valve-commercial cylinder reversing valve-lower hydraulic cylinder reversing valve-relay delay when the oil tank returns quickly, after that time, the pressure is maintained for the night, the electromagnet is energized, the right position of the pilot valve is involved in the system, and the pressure relief valve makes the upper hydraulic pressure The cylinder reversing valve is also connected to the system in the right position. At this time, the hydraulic control check valve is opened, and the upper hydraulic cylinder returns quickly. When the upper slider rises to the stop and hits the original position limit switch, the electromagnet is powered off, and both the pilot valve and the upper hydraulic cylinder reversing valve are in Median. At this time, the upper hydraulic cylinder does not move intermittently. The hydraulic pump is unloaded at lower pressures.

62216492b3b94

Four-column hydraulic press When the slider goes down to a certain position, the travel switch is pressed down. At this time, only the hydraulic pump supplies a certain flow of pressure oil to the upper chamber of the master cylinder. In addition, the upper chamber of the master cylinder has a large area, so the slider moves down slowly and pressurizes , after touching the workpiece, the pressure rises. Holding time delay. When the pressure in the system rises to the action of the pressure relay gas, the electric signal is issued at this time, the four-column hydraulic press controls the electromagnet to be cut off, the pilot valve and the upper cylinder reversing valve are both in the neutral position, and the system enters the pressure maintaining.