Causes of gear pump vibration in single arm hydraulic press

①Whether the single-arm hydraulic press gear pump sucks oil with bubbles from the oil tank.
② Check whether the rubber parts of the single-arm hydraulic press motor and pump coupling are damaged or missing. Damaged or missing rubber parts of the coupling should be replaced or supplemented.
③ Check the concentricity of the installation of the single-arm hydraulic pump and the motor. There should be a requirement to adjust the concentricity of the installation of the pump to the motor.
④ Check the key or spline of the coupling. Wear can cause radial runout of the rotating parts.
⑤ Check the end face seals where the pump body is in direct contact with the end caps on both sides. If the flatness of the contact surface does not meet the specified requirements, the pump is easy to inhale air during operation. The single-arm hydraulic press can use the grinding paste to grind back and forth in a figure-8 route on the flat plate, or it can be ground on a surface grinder so that the flatness does not exceed 5mm, and the perpendicularity between the plane and the hole is maintained.
⑥ Check the contact point between the end cover hole of the single-arm hydraulic pump and the outer diameter of the gland. If the fit is not good, air can easily penetrate from this contact point. If the gland is made of plastic, due to its damage or deformation due to temperature changes, the seal will not be tight and air will enter. It can be sealed with an adhesive such as epoxy resin.
⑦ Check the damage or wear of the parts in the pump. Damaged or severely worn parts in the pump will produce vibration and noise. For example, the tooth profile error or pitch error is large, the two gears are in poor contact, the tooth surface roughness is high, the common normal length is out of tolerance, the tooth flank is too small, the contact area of the two gears is not on the indexing circle, etc. At this time, the gear grinding can be replaced. The needle roller ball or cage of the bearing is damaged, the long and short shaft journals are worn, etc., which can cause the bearing to rotate poorly and produce mechanical noise. At this time, it is necessary to disassemble the gear pump, replace the bearing, and repair or replace the pump shaft of the single-arm hydraulic machine.





